Duravú Bullet Proof Shields
How do I properly install a "Bullet-Proof" Shield?
Occasionally dust or lint can find its way onto the adhesive side of the shield, especially during installation. To avoid this problem, we recommend peeling the sticker slightly, then lining up the shield with the top portion of the iPod. Slowly begin to peel the sticker, and apply the shield to the face of the iPod. This will ensure no dust or lint finds its way in between the shield and the iPod. Afterwards, use a micro-fiber cloth to push out any remaining air bubbles.
iGadget Grips
Does this accessory work only for the iPod?
No. The iGadget Grip is perfect for holding your cell phone too!
Do any of your products contain natural rubber or latex?
None of HandStands' current products contain any natural rubber, and all products are completely latex free.
Does the iSnug 2-Pack Set fit the 60 GB Video iPod?
Yes! The iSnug has been updated to work with Apple's 30 and 60 GB Video iPods. Please note that some iSnugs may require a slight modification to allow for the new location of the headphone jack. This is easily accomplished by doing the following:
| 1. | Remove the EVA foam insert. |
| 2. | Make a small mark on the foam where the headphone jack is located. |
| 3. | Use a utility knife to cut about a 5/8" wide slit in the foam. Do not cut completely through the bottom of the foam. |
| 4. | Remove the foam piece, and place it in the old headphone gap. |
| 5. | Place the foam insert back into your iSnug case. |
| 6. | Congratulations! Your iSnug is now compatible with the Video iPod! |
Please note that in the future shipping iSnugs will contain two cutouts, allowing compatibility with all full-sized iPods regardless of the location of the headphone jack.
